A few things i Have Learned About Building My Own Tiki Bar

  • As a tiki bar owner now for over 5 years I have learned stuff that If only might have done and stuff that I'd never do again. I have to reveal to you my mistakes and improvements to my tiki bar.

    First I have to discuss a couple of things that we learned building my personal outside bar. Outside, need I have faith that more! The weather conditions in your town will determine how you construct your bar. Listed below are ideas you need to pay attention to if you're building a third party tiki bar.

    Your Climate- If you live in a place which includes warm summers and cold winters, then you will encounter exactly the same obstacles that we came against. Be sure you use treated wood for any surface which comes touching the soil. If you do not follow this rule in that case your tiki bar will soon shrink and crack. That's the reason you have to use treated lumber; it shrinks less and definately will last for a long time. If you have wood that is confronted with the next thunderstorm you need to seriously consider the type of wood you utilize and proper treating from the wood after it is installed.

    Insects- We used white cedar logs to the construction of my roof structure because cedar should be less vulnerable to damage from insects. Okay, throw that out your window, I went along for several years with no insect problems until last year. I noticed wood dust and small chips lying on my own bar top. I believed it was coming from thatch falling or breaking up but amazed to discover I'd carpenter bees! After inspecting my white cedar logs I discovered holes about 3/8 inch bored in some of my logs. I knew I needed to address this example immediately and after performing some research I called an exterminator. A carpenter bee looks almost comparable to a standard bumble bee except no hair on abdomen as well as the men're can not sting. They love natural cedar! May sure applying either wood preservative or possibly a good Valspar varnish to your logs.

    Bar Top- There are many different opinions about what for your bar top. I did skimp here and sorry I did! It is strongly recommended that you use marine plywood to the bar top, and even for good reason. We used the subsequent best thing I figured, oak plywood. The oak plywood was for the very first year or so, applying about ten coats of marine varnish. This is fine except the edges from the plywood are extremely tough to seal. Once water started stepping into wood I'd just problems! To resolve my problem I applied glass tile to my tiki bar top using waterproof glue and grout. The marine plywood is very expensive but well worth the money.

    Palm Thatch- Lifespan of your respective roof for the tiki bar will definitely be based upon your weather. It is possible to figure on replacing your thatch palms no less than every couple of years. Sizzling hot that you can eliminate this issue is to buy good quality commercial synthetic thatch. Very good of outdoor restaurants with tiki thatch roofs has evolved the need for this synthetic thatch. I recently re-thatched my bar with sealed thatch that may give you an extra A couple of years of additional life.

    Securing Your Bar- Another thing I have to mention here, is anchoring your bar down is essential item. I will be lucky that my bar is looking at a concrete apron throughout my pool area. We used drop in concrete anchors in order to avoid my bar from blowing in high winds.

    To read more about tiki mugs visit this net page: click here

0 comments